I saw a 3d printer using plastic pellets instead of filament.
Is this a good idea? Because I never saw anyone doing this.
Seller says “in this way it won’t run out of filament” but I have the impression of imprecise extrusions (machine was fitted with a big 0.8mm nozzle)
This was my first question how the hell do you do retraction???
A little vacuum pump, like a carburetor on a motorcycle from the 70’s? Hell if I know, but that’s my idea.
I mean the same way, retraction isn’t pulling the molten filament out of the nozzle in FDM so I’m either filament or peeler based extrusion you just run it in reverse briefly.
Do you need to? If you put a valve on the nozzle, then you can stop flow even more reliably than retraction does